ECS4100 Series CLI Reference Guide-R07

Chapter 29 | CFM Commands
Defining CFM Structures
– 817 –
show ethernet cfm
maintenance-points
remote detail
This command displays detailed CFM information about a remote MEP in the
continuity check database.
Syntax
show ethernet cfm maintenance-points remote detail
{mac mac-address | mpid mpid}
[domain domain-name | level level-id]
mac-address – MAC address of a remote maintenance point.
This address can be entered in either of the following formats: xx-xx-xx-xx-
xx-xx or xxxxxxxxxxxx
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
level-id – Authorized maintenance level for this domain. (Range: 0-7)
Table 165: show ethernet cfm maintenance-points local detail mep - display
Field Description
MPID MEP identifier
MD Name The maintenance domain for this entry.
MA Name Maintenance association to which this remote MEP belongs
MA Name Format The format of the Maintenance Association name, including primary VID,
character string, unsigned Integer 16, or RFC 2865 VPN ID
Level Maintenance level of the local maintenance point
Direction The direction in which the MEP faces on the Bridge port (up or down).
Interface The port to which this MEP is attached.
CC Status Shows if the MEP will generate CCM messages.
MAC Address MAC address of the local maintenance point. (If a CCM for the specified
remote MEP has never been received or the local MEP record times out,
the address will be set to the initial value of all Fs.)
Defect Condition Shows the defect detected on the MEP.
Received RDI Receive status of remote defect indication (RDI) messages on the MEP.
AIS Status Shows if MEPs within the specified MA are enabled to send frames with
AIS information following detection of defect conditions.
AIS Period The interval at which AIS information is sent.
AIS Transmit Level The maintenance level at which AIS information will be sent for the
specified MEP.
Suppress Alarm Shows if the specified MEP is configured to suppress sending frames
containing AIS information following the detection of defect conditions.
Suppressing Alarms Shows if the specified MEP is currently suppressing sending frames
containing AIS information following the detection of defect conditions.