CLI Reference Guide-R04

Chapter 4 | System Management Commands
Time
– 162 –
1. 192.168.2.243
SMTP Minimum Severity Level: 6
SMTP Destination E-mail Addresses
------------------------------------------------
1. [e-mail]
SMTP Source E-mail Address: [e-mail]
SMTP Status: Enabled
Console#
Time
The system clock can be dynamically set by polling a set of specified time servers
(NTP or SNTP). Maintaining an accurate time on the switch enables the system log
to record meaningful dates and times for event entries. If the clock is not set, the
switch will only record the time from the factory default set at the last bootup.
Table 25: Time Commands
Command Function Mode
SNTP Commands
sntp client Accepts time from specified time servers GC
sntp poll Sets the interval at which the client polls for time GC
sntp server Specifies one or more time servers GC
show sntp Shows current SNTP configuration settings NE, PE
NTP Commands
ntp authenticate Enables authentication for NTP traffic GC
ntp authentication-key Configures authentication keys GC
ntp client Enables the NTP client for time updates from specified
servers
GC
ntp server Specifies NTP servers to poll for time updates GC
show ntp Shows current NTP configuration settings NE, PE
Manual Configuration Commands
clock summer-time (date)
Configures summer time
*
for the switch’s internal clock
GC
clock summer-time
(predefined)
Configures summer time for the switch’s internal clock GC
clock summer-time
(recurring)
Configures summer time for the switch’s internal clock GC
clock timezone Sets the time zone for the switch’s internal clock GC
clock timezone-predefined Sets the time zone for the switch’s internal clock GC