CLI Reference Guide-R04

Chapter 8 | User Authentication Commands
RADIUS Client
– 237 –
port-number - RADIUS server UDP port used for accounting messages.
(Range: 1-65535)
Default Setting
1813
Command Mode
Global Configuration
Example
Console(config)#radius-server acct-port 181
Console(config)#
radius-server
auth-port
This command sets the RADIUS server network port. Use the no form to restore the
default.
Syntax
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
Default Setting
1812
Command Mode
Global Configuration
Example
Console(config)#radius-server auth-port 181
Console(config)#
radius-server host This command specifies primary and backup RADIUS servers, and authentication
and accounting parameters that apply to each server. Use the no form to remove a
specified server.
Syntax
radius-server index host host-ip-address [acct-port acct-port] [auth-port auth-
port] [encrypted-key key] [key key] [retransmit retransmit]
[timeout timeout]
no radius-server index