CLI Reference Guide-R04

Chapter 8 | User Authentication Commands
PPPoE Intermediate Agent
– 288 –
Example
Console#show management all-client
Management IP Filter
HTTP Client:
Start IP Address End IP Address
--------------------------------------- -------------------------------------
--
192.168.1.1 192.168.1.100
192.168.2.1 192.168.2.254
SNMP Client:
Start IP Address End IP Address
--------------------------------------- -------------------------------------
--
10.1.2.1 10.1.2.12
171.1.2.34 171.1.2.50
Telnet Client:
Start IP Address End IP Address
--------------------------------------- -------------------------------------
--
192.168.1.1 192.168.1.100
192.168.2.1 192.168.2.254
Console#
PPPoE Intermediate Agent
This section describes commands used to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages between
a client and broadband remote access servers.
Table 50: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe intermediate-agent Enables the PPPoE IA globally on the switch GC
pppoe intermediate-agent
format-type
Sets the access node identifier and generic error message
for the switch
GC
pppoe intermediate-agent
port-enable
Enables the PPPoE IA on an interface IC
pppoe intermediate-agent
port-format-type
Sets the circuit-id or remote-id for an interface IC
pppoe intermediate-agent
port-format-type remote-
id-delimiter
Sets the remote-id delimiter for an interface IC
pppoe intermediate-agent
trust
Sets the trust mode for an interface IC
pppoe intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE Discovery
packets sent from a PPPoE server
IC
clear pppoe intermediate-
agent statistics
Clears PPPoE IA statistics PE