CLI Reference Guide-R04

Chapter 11 | Interface Commands
– 408 –
Transceiver Threshold Configuration
transceiver-monitor Sends a trap when any of the transceiver’s operational
values fall outside specified thresholds
IC
transceiver-threshold-auto Uses default threshold settings obtained from the
transceiver to determine when an alarm or trap message
should be sent
IC
transceiver-threshold
current
Sets thresholds for transceiver current which can be used
to trigger an alarm or warning message
IC
transceiver-threshold
rx-power
Sets thresholds for the transceiver power level of the
received signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
temperature
Sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message
IC
transceiver-threshold
tx-power
Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
voltage
Sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message
IC
show interfaces transceiver Displays the temperature, voltage, bias current, transmit
power, and receive power
PE
show interfaces transceiver-
threshold
Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power
PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
test loop internal Performs an internal loop back test on the specified port PE
show loop internal Shows the results of a loop back test PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
Table 74: Interface Commands (Continued)
Command Function Mode