CLI Reference Guide-R04

Chapter 18 | Smart Pair Commands
Smart Pair Concept
– 511 –
wtr-delay This command sets the wait-to-restore delay for a smart pair. Use the no form of the
command to set the delay to the default value.
Syntax
wtr-delay seconds
seconds - delay in seconds (Range:0, 5-3600)
Default Setting
None
Command Mode
Smart Pair Configuration Mode
Command Usage
◆ If the wtr-delay parameter is set to 0, traffic will not be restored after a failed
port is recovered.
◆ If the wtr-delay is set from 5 to 3600 (seconds) and a failed smart port recovers,
traffic will be restored to the port after the configured delay in seconds.
Example
Console(config-smart-pair)#wtr-delay 120
Console(config-smart-pair)#
show smart-pair This command shows the configured smart pairs on the switch.
Default Setting
None
Command Mode
Privileged Exec