Manualshelf

CLI Reference Guide-R04

ManualsBrandsEdgecore Networks ManualsFixed Broadband AccessENHANCED TEMPERATURE L2+ GIGABIT ETHERNET ACCESS / AGGREGATION SWITCH WITH 4 X 10G UPLINKS
551552553554555556557558559560
Table Of Contents
Chapter 21
| ERPS Commands
– 553 –
◆ Once enabled, the RPL owner node and non-owner node state machines will
start, and the ring will enter idle state if no signal failures are detected.
Example
Console(config-erps-ring)#enable
Console(config-erps-ring)#
Related Commands
erps (547)
enable (instance) This command activates the current ERPS instance. Use the no form to disable the
current instance.
Syntax
[no] enable
Default Setting
Disabled
Command Mode
ERPS Instance Configuration
Command Usage
◆ Before enabling an instance, the global ERPS function should be enabled with
the erps command, the ring enabled with the enable (ring) command, the east
and west ring ports configured on each node with the ring-port command, the
RPL owner specified with the rpl owner command, and the control VLAN
configured with the control-vlan command.
◆ Once enabled, the RPL owner node and non-owner node state machines will
start, and the instance will enter idle state if no signal failures are detected.
Example
Console(config-erps-inst)#enable
Console(config-erps-inst)#
Related Commands
erps (547)
meg-level This command sets the Maintenance Entity Group level for an instance. Use the no
form to restore the default setting.
Syntax
meg-level level