CLI Reference Guide-R04

Chapter 21 | ERPS Commands
– 557 –
◆ Note that is not mandatory to declare an RPL neighbor.
Example
Console(config-erps-inst)#rpl neighbor
Console(config-erps-inst)#
wtr-timer This command sets the wait-to-restore timer which is used to verify that the ring
has stabilized before blocking the RPL after recovery from a signal failure. Use the
no form to restore the default setting.
Syntax
wtr-timer minutes
no wtr-timer
minutes - The wait-to-restore timer is used to verify that the ring has
stabilized before blocking the RPL after recovery from a signal failure.
(Range: 5-12 minutes)
Default Setting
5 minutes
Command Mode
ERPS Instance Configuration
Command Usage
If the switch goes into ring protection state due to a signal failure, after the failure
condition is cleared, the RPL owner will start the wait-to-restore timer and wait until
it expires to verify that the ring has stabilized before blocking the RPL and returning
to the Idle (normal operating) state.
Example
Console(config-erps-inst)#wtr-timer 10
Console(config-erps-inst)#