CLI Reference Guide-R04

Chapter 21 | ERPS Commands
– 569 –
◆ The version number is automatically set to “1” when a ring node, supporting
only the functionalities of G.8032v1, exists on the same ring with other nodes
that support G.8032v2.
◆ When ring nodes running G.8032v1 and G.8032v2 co-exist on a ring, the ring ID
of each node is configured as “1”.
◆ In version 1, the MAC address 01-19-A7-00-00-01 is used for the node identifier.
The raps-def-mac command has no effect.
Example
Console(config-erps-inst)#version 1
Console(config-erps-inst)#
inclusion-vlan Use this command to specify VLAN groups that are to be on the inclusion list of an
ERPS instance. Use the no form of the command to removed the VLAN from the list.
Syntax
[no] inclusion-vlan vlan-group-name
vlan-group-name - Name of the VLAN group. (Range: 1-12 characters).
Default Setting
None
Command Mode
ERPS Instance Configuration
Command Usage
◆ VLANs that are on the inclusion list are protected by the ERPS instance.
◆ Any VLAN not listed on either the inclusion or exclusion list will be blocked on
ring ports.
◆ Use the show erps statistics command to view the inclusion-vlan list of VLAN
IDs.
◆ Traffic from control VLANs, inclusion VLANs, and exclusion VLANs of an ERPS
instance will be forwarded by non-ERPS ring ports.
Example
Console(config-erps-inst)#inclusion-vlan vlgroup3
Console(config-erps-inst)#