CLI Reference Guide-R04

Chapter 21 | ERPS Commands
– 576 –
show erps This command displays status information for all configured VLAN groups, rings,
and instances, or for a specified VLAN group, ring, or instance.
Syntax
show erps {[vlan-group vlan-group-name] | [ring ring-name] |
[instance instance-name]}
vlan-group - Keyword to display ERPS VLAN group settings.
vlan-group-name – Name of the VLAN group. (Range: 1-12 characters).
ring - Keyword to display ERPS ring configuration settings.
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
instance - Keyword to display ERPS instance configuration settings.
instance-name - Name of a specific ERPS instance. (Range: 1-12 characters)
Command Mode
Privileged Exec
Example
This example displays a summary of all the ERPS VLAN groups configured on the
switch.
Console#show erps vlan-group
ERPS Status : Disabled
ERPS node-id : B8-6A-97-41-F3-83
Number of ERPS Vgroup : 1
VLAN-group ID VLANs
------------ --- ----------------------------------------
vlgroup3 1 3,6,9
Table 100: show erps statistics - detailed display description
Field Description
Interface The direction, and port or trunk which is configured as a ring port.
Local SF A signal fault generated on a link to the local node.
Local Clear SF The number of times a clear command was issued to terminate
protection state entered through a forced switch or manual switch
SF The number of signal fault messages
NR The number of no request messages
NR-RB The number no request - RPL blocked messages
FS The number of forced switch messages
MS The number of manual switch messages
EVENT Any request/state message, excluding FS, SF, MS, and NR
HEALTH The number of non-standard health-check messages