CLI Reference Guide-R04

Chapter 24 | Quality of Service Commands
– 662 –
service-policy This command applies a policy map defined by the policy-map command to the
ingress side of a particular interface. Use the no form to remove this mapping.
Syntax
[no] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ Only one policy map can be assigned to an interface.
◆ First define a class map, then define a policy map, and finally use the service-
policy command to bind the policy map to the required interface.
◆ The switch does not allow a policy map to be bound to an interface for egress
traffic.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#
show class-map This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map [class-map-name]
class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec