CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
IGMP Snooping
– 682 –
ip igmp snooping vlan
query-resp-intvl
This command configures the maximum time the system waits for a response to
general queries. Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-resp-intvl interval
no ip igmp snooping vlan vlan-id query-resp-intvl
vlan-id - VLAN ID (Range: 1-4094)
interval - The maximum time the system waits for a response to general
queries. (Range: 10-31740 tenths of a second in multiples of 10)
Default Setting
100 (10 seconds)
Command Mode
Global Configuration
Command Usage
This command applies when the switch is serving as the querier (page 669), or as a
proxy host when IGMP snooping proxy reporting is enabled (page 669).
Example
Console(config)#ip igmp snooping vlan 1 query-resp-intvl 20
Console(config)#
ip igmp snooping vlan
static
This command adds a port to a multicast group. Use the no form to remove the
port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4094)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-26)
Default Setting
None