CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 693 –
Example
Console(config)#ip igmp igmp-with-pppoe
Console(config)#
ip igmp profile This command creates an IGMP filter profile number and enters IGMP profile
configuration mode. Use the no form to delete a profile number.
Syntax
[no] ip igmp profile profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Global Configuration
Command Usage
A profile defines the multicast groups that a subscriber is permitted or denied to
join. The same profile can be applied to many interfaces, but only one profile can
be assigned to one interface. Each profile has only one access mode; either permit
or deny.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
permit, deny This command sets the access mode for an IGMP filter profile.
Syntax
{permit | deny}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
◆ Each profile has only one access mode; either permit or deny.
◆ When the access mode is set to permit, IGMP join reports are processed when a
multicast group falls within the controlled range. When the access mode is set