CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MLD Snooping
– 707 –
ipv6 mld snooping
query-max-response-
time
This command configures the maximum response time advertised in MLD general
queries. Use the no form to restore the default.
Syntax
ipv6 mld snooping query-max-response-time seconds
no ipv6 mld snooping query-max-response-time
seconds - The maximum response time allowed for MLD general queries.
(Range: 5-25 seconds)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
This command controls how long the host has to respond to an MLD Query
message before the switch deletes the group if it is the last member.
Example
Console(config)#ipv6 mld snooping query-max-response-time 15
Console(config)#
ipv6 mld snooping
proxy-reporting
This command enables MLD Snooping with Proxy Reporting. Use the no form to
restore the default setting.
Syntax
[no] ipv6 mld snooping proxy-reporting
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ When proxy reporting is enabled with this command, reports received from
downstream hosts are summarized and used to build internal membership
states. Proxy-reporting devices may use the IPv6 address configured on this
VLAN or Source IP address from received report message as source address
when forwarding any summarized reports upstream.