CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MLD Snooping
– 710 –
ipv6 mld snooping
unsolicited-report-
interval
This command specifies how often the upstream interface should transmit
unsolicited IGMP reports when proxy reporting is enabled. Use the no form to
restore the default value.
Syntax
ipv6 mld snooping unsolicited-report-interval seconds
no ipv6 mld snooping unsolicited-report-interval
seconds - The interval at which to issue unsolicited reports.
(Range: 1-65535 seconds)
Default Setting
400 seconds
Command Mode
Global Configuration
Command Usage
◆ When a new upstream interface (that is, uplink port) starts up, the switch sends
unsolicited reports for all currently learned multicast channels out through the
new upstream interface.
◆ This command only applies when proxy reporting is enabled (see page 707).
Example
Console(config)#ipv6 mld snooping unsolicited-report-interval 5
Console(config)#
ipv6 mld snooping
version
This command configures the MLD snooping version. Use the no form to restore
the default.
Syntax
ipv6 mld snooping version {1 | 2}
no ipv6 mld snooping version
1 - MLD version 1.
2 - MLD version 2.
Default Setting
Version 2
Command Mode
Global Configuration