CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv4
– 729 –
Related Commands
mvr profile (730)
mvr domain This command enables Multicast VLAN Registration (MVR) for a specific domain.
Use the no form of this command to disable MVR for a domain.
Syntax
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR
must be configured for an IGMP version 1 host, the multicast groups must be
statically assigned using the mvr vlan group command.
Example
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr priority This command assigns a priority to all multicast traffic in the MVR VLAN. Use the no
form of this command to restore the default setting.
Syntax
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded into the
MVR VLAN. (Range: 0-7, where 7 is the highest priority)
Default Setting
Disabled
Command Mode
Global Configuration