CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv4
– 731 –
Example
The following example maps a range of MVR group addresses to a profile:
Console(config)#mvr profile rd 228.1.23.1 228.1.23.10
Console(config)#
mvr proxy-query-
interval
This command configures the interval at which the receiver port sends out general
queries. Use the no form to restore the default setting.
Syntax
mvr proxy-query-interval interval
no mvr proxy-query-interval
interval - The interval at which the receiver port sends out general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Command Usage
This command sets the general query interval at which active receiver ports send
out general queries. This interval is only effective when proxy switching is enabled
with the mvr proxy-switching command.
Example
This example sets the proxy query interval for MVR proxy switching.
Console(config)#mvr proxy-query-interval 250
Console(config)#
mvr proxy-switching This command enables MVR proxy switching, where the source port acts as a host,
and the receiver port acts as an MVR router with querier service enabled. Use the
no form to disable this function.
Syntax
[no] mvr proxy-switching
Default Setting
Enabled