CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv4
– 733 –
mvr robustness-value This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
Default Setting
2
Command Mode
Global Configuration
Command Usage
◆ This command is used to set the number of times report messages are sent
upstream when changes are learned about downstream groups, and the
number of times group-specific queries are sent to downstream receiver ports.
◆ This command only takes effect when MVR proxy switching is enabled.
Example
Console(config)#mvr robustness-value 5
Console(config)#
Related Commands
mvr proxy-switching (731)
mvr source-port-
mode dynamic
This command configures the switch to only forward multicast streams which the
source port has dynamically joined. Use the no form to restore the default setting.
Syntax
mvr source-port-mode dynamic
no mvr source-port-mode
Default Setting
Forwards all multicast streams which have been specified in a profile and bound to
a domain.
Command Mode
Global Configuration