CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv6
– 750 –
MVR for IPv6
This section describes commands used to configure Multicast VLAN Registration for
IPv6 (MVR6). A single network-wide VLAN can be used to transmit multicast traffic
(such as television channels) across a service provider’s network. Any multicast
traffic entering an MVR6 VLAN is sent to all subscribers. This can significantly reduce
to processing overhead required to dynamically monitor and establish the
distribution tree for a normal multicast VLAN. Also note that MVR6 maintains the
user isolation and data security provided by VLAN segregation by passing only
multicast traffic into other VLANs to which the subscribers belong.
Table 144: Multicast VLAN Registration for IPv6 Commands
Command Function Mode
mvr6 associated-profile Binds the MVR group addresses specified in a profile to an
MVR domain
GC
mvr6 domain Enables MVR for a specific domain GC
mvr6 priority Assigns a priority to all multicast traffic in the MVR6
VLAN
GC
mvr6 profile Maps a range of MVR group addresses to a profile GC
mvr6 proxy-query-interval Configures the interval at which the receiver port sends out
general queries.
GC
mvr6 proxy-switching Enables MVR proxy switching, where the source port acts as a
host, and the receiver port acts as an MVR router with querier
service enabled
GC
mvr6 robustness-value Configures the expected packet loss, and thereby the number
of times to generate report and group-specific queries
GC
mvr6 source-port-mode
dynamic
Configures the switch to only forward multicast streams
which the source port has dynamically joined
GC
mvr6 upstream-source-ip Configures the source IP address assigned to all control
packets sent upstream
GC
mvr6 vlan Specifies the VLAN through which MVR multicast data is
received
GC
mvr6 immediate-leave Enables immediate leave capability IC
mvr6 type Configures an interface as an MVR receiver or source port IC
mvr6 vlan group Statically binds a multicast group to a port IC
clear mvr6 groups dynamic Clears multicast group information dynamically learned
through MVR
PE
clear mvr6 statistics Clears MVR statistics PE
show mvr6 Shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current
number of group addresses, and the upstream source IP
address
PE
show mvr6 associated-
profile
Shows the profiles bound the specified domain PE
show mvr6 interface Shows MVR settings for interfaces attached to the MVR VLAN PE