CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv6
– 752 –
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
When MVR6 is enabled on a domain, any multicast data associated with an MVR6
group is sent from all designated source ports, to all receiver ports that have
registered to receive data from that multicast group.
Example
The following example enables MVR6 for domain 1:
Console(config)#mvr6 domain 1
Console(config)#
mvr6 priority This command assigns a priority to all multicast traffic in the MVR6 VLAN. Use the
no form of this command to restore the default setting.
Syntax
mvr6 priority priority
no mvr6 priority
priority - The CoS priority assigned to all multicast traffic forwarded into the
MVR6 VLAN. (Range: 0-7, where 7 is the highest priority)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
This command can be used to set a high priority for low-latency multicast traffic
such as a video-conference, or to set a low priority for normal multicast traffic not
sensitive to latency.
Example
Console(config)#mvr6 priority 6
Console(config)#
Related Commands
show mvr6 (763)