CLI Reference Guide-R04

Chapter 25 | Multicast Filtering Commands
MVR for IPv6
– 754 –
mvr6 proxy-query-
interval
This command configures the interval at which the receiver port sends out general
queries. Use the no form to restore the default setting.
Syntax
mvr6 proxy-query-interval interval
no mv6r proxy-query-interval
interval - The interval at which the receiver port sends out general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Command Usage
This command sets the general query interval at which active receiver ports send
out general queries. This interval is only effective when proxy switching is enabled
with the mvr6 proxy-switching command.
Example
This example sets the proxy query interval for MVR6.
Console(config)#mvr6 proxy-query-interval 100
Console(config)#
mvr6 proxy-switching This command enables MVR6 proxy switching, where the source port acts as a host,
and the receiver port acts as an MVR6 router with querier service enabled. Use the
no form to disable this function.
Syntax
[no] mvr6 proxy-switching
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
◆ When MVR6 proxy-switching is enabled, an MVR6 source port serves as the
upstream or host interface, and the MVR receiver port serves as the querier. The
source port performs only the host portion of MVR6 by sending summarized
membership reports, and automatically disables MVR6 router functions.