CLI Reference Guide-R04

Chapter 27 | CFM Commands
Defining CFM Structures
– 817 –
show ethernet cfm
maintenance-points
local
This command displays the maintenance points configured on this device.
Syntax
show ethernet cfm maintenance-points local
{mep [domain domain-name | interface interface | level level-id] | mip
[domain domain-name | level level-id]}
mep – Displays only local maintenance end points.
mip – Displays only local maintenance intermediate points.
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-26)
level-id – Maintenance level for this domain. (Range: 0-7)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
◆ Use the mep keyword with this command to display the MEPs configured on
this device as DSAPs through the ethernet cfm mep command.
◆ Using the mip keyword with this command to display the MIPs generated on
this device by the CFM protocol when the mip-creation method is set to either
“default” or “explicit” by the ethernet cfm domain command or the ma index
name command.
Example
This example shows all MEPs configured on this device for maintenance domain rd.
Console#show ethernet cfm maintenance-points local mep
MPID MD Name Level Direct VLAN Port CC Status MAC Address
---- ---------------- ----- ------ ---- -------- --------- -----------------
1 rd 0 UP 1 Eth 1/ 1 Enabled 00-12-CF-3A-A8-C0
Console#