CLI Reference Guide-R04

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 88 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
Spanning Tree Configures Spanning Tree settings for the switch 515
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service
provider networks
545
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures protocol VLANs,
voice VLANs, and QinQ tunneling
579
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for TCP/UDP traffic types, IP precedence, and
DSCP
627
Quality of Service Configures Differentiated Services 647
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
665
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
773
Connectivity Fault
Management
Configures connectivity monitoring using continuity check
messages, fault verification through loopback messages, and
fault isolation by examining end-to-end connections
between Provider Edge devices or between Customer Edge
devices
801
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and maintain
the links to subscriber CPEs
843
Domain Name Service Configures DNS services. 855
Dynamic Host
Configuration Protocol
Configures DHCP client and relay functions 865
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
893
IP Routing Configures static routing 947
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 6: Command Group Index (Continued)
Command Group Description Page