CLI Reference Guide-R04

Chapter 31 | IP Interface Commands
IPv6 Interface
– 909 –
Command Mode
Interface Configuration (VLAN)
Command Usage
◆ If a link local address has not yet been assigned to this interface, this command
will dynamically generate a global unicast address (if a global prefix is included
in received router advertisements) and a link local address for the interface.
(The link-local address is made with an address prefix of FE80 and a host
portion based the switch’s MAC address in modified EUI-64 format.
◆ If a duplicate address is detected, a warning message is sent to the console.
◆ When DHCPv6 is restarted, the switch may attempt to acquire an IP address
prefix through stateful address autoconfiguration. If the router advertisements
have the “other stateful configuration” flag set, the switch may also attempt to
acquire other non-address configuration information (such as a default
gateway) from a DHCPv6 server when DHCPv6 is restarted.
◆ If IPv6 router advertisements are enabled and this command is configured, the
IPv6 address auto configuration will fail to enable.
Example
This example assigns a dynamic global unicast address to the switch.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address autoconfig
Console(config-if)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is stale, AUTOCONFIG is enabled
Link-Local Address:
FE80::2E0:CFF:FE00:FD/64
Global Unicast Address(es):
2002:1000:AA22:BB66::1000/64, subnet is 2002:1000:AA22:BB66::/
64[AUTOCONFIG]
valid lifetime -1 preferred lifetime -1
Joined Group Address(es):
FF02::1:FF00:1000
FF02::1:FF00:FD
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
Related Commands
ipv6 address (907)
show ipv6 interface (916)