CLI Reference Guide-R04

Chapter 31 | IP Interface Commands
IPv6 Interface
– 937 –
Eth 1/ 1 Yes
Console#
show ipv6 neighbors This command displays information in the IPv6 neighbor discovery cache.
Syntax
show ipv6 neighbors [vlan vlan-id | ipv6-address]
vlan-id - VLAN ID (Range: 1-4094)
ipv6-address - The IPv6 address of a neighbor device. You can specify either
a link-local or global unicast address formatted according to RFC 2373 “IPv6
Addressing Architecture,” using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used in the address to indicate the
appropriate number of zeros required to fill the undefined fields.
Default Setting
All IPv6 neighbor discovery cache entries are displayed.
Command Mode
Privileged Exec
Example
The following shows all known IPv6 neighbors for this switch:
Console#show ipv6 neighbors
State: I1 - Incomplete, I2 - Invalid, R - Reachable, S - Stale, D - Delay,
P1 - Probe, P2 - Permanent, U - Unknown
IPv6 Address Age Link-layer Addr State Interface
--------------------------------------- ---- ----------------- ----- --------
FE80::2E0:CFF:FE9C:CA10 4 00-E0-0C-9C-CA-10 R 1
Console#
Table 182: show ipv6 neighbors - display description
Field Description
IPv6 Address IPv6 address of neighbor
Age The time since the address was verified as reachable (in seconds). A static entry is
indicated by the value “Permanent.”
Link-layer Addr Physical layer MAC address.