CLI Reference Guide-R04

– 947 –
30 IP Routing Commands
After network interfaces are configured for the switch, the paths used to send
traffic between different interfaces must be set. If routing is enabled on the switch,
traffic will automatically be forwarded between all of the local subnetworks.
However, to forward traffic to devices on other subnetworks, either configure fixed
paths with static routing commands, or enable a dynamic routing protocol that
exchanges information with other routers on the network to automatically
determine the best path to any subnetwork.
This section includes commands for static routing. These commands are used to
connect between different local subnetworks or to connect the router to the
enterprise network.
Global Routing Configuration
.
Table 203: IP Routing Commands
Command Group Function
Global Routing Configuration Configures global parameters for static routing, displays the routing
table and statistics for protocols used to exchange routing
information
Table 204: Global Routing Configuration Commands
Command Function Mode
IPv4 Commands
ip route Configures static routes GC
show ip route Displays specified entries in the routing table PE
show ip route database Displays static entries in the routing table PE
show ip route summary Displays summary information for the routing table PE
IPv6 Commands
ipv6 route Configures static routes GC
show ipv6 route Displays specified entries in the routing table PE