ECS4120 series V1.2.2.30 firmware release note

ENGINEERING RELEASE NOTES
1/2010 Subject to Change Without Notice Page: 7 of 25
ES4528BH2-HPoE-0815-EC-00849
ERPS: After shutdown and no shutdown Ring port in maximum instance setting; Port
cannot receive all VLAN traffic.
ES4528BH2-HPoE-0815-EC-00808
ERPS WTR timer should support range 1 - 12 minutes
ES4528BH2-HPoE-0815-EC-00790
DHCP Snooping trust port will remove the option 82..
ES4528BH2-HPoE-0815-EC-00731
[Enhance] ERPS with Multiple Instance MIB
ECS4120-Stacking-00122
Remove duplicate warning message while performing Dynamic DHCP-provision
Runtime V1.2.2.14; Loader V0.0.3.0
ES4528BH2-HPoE-0815-EC-00860
[WEB] TACACS supports IPv6
ES4528BH2-HPoE-0815-EC-00851
Modify the place of spanning-tree command in CLI running.
ES4528BH2-HPoE-0815-EC-00848
Tacacs support over ipv6
ES4528BH2-HPoE-0815-EC-00843
SSH: The DSA option should be removed on WEB page
ES4528BH2-HPoE-0815-EC-00840
[Enhancement] SW WatchDog monitor GVRP_GROUP
ES4528BH2-HPoE-0815-EC-00839
IPv6 address prefix >64 for 4120 CLI
ES4528BH2-HPoE-0815-EC-00836
[TACACS] Since authorization is supported, it's not necessary to grant privilege
automatically after authentication.
ES4528BH2-HPoE-0815-EC-00831
when port description length less then 8, web gui/snmp display problem
ES4528BH2-HPoE-0815-EC-00829
Support DHCP op82 remote-id "port description" only (without any remote-id prefix)
ES4528BH2-HPoE-0815-EC-00828
DHCPSNP option82 remote-id configure delimiter as 0(null), then Port Description
field will not exist
ES4528BH2-HPoE-0815-EC-00835
ECS4120-28F Inserting SGMII RJ45 SFP at port 1-24 when boot-up, affect config.
ES4528BH2-HPoE-0815-EC-00872
ECS4120-28P PoE powering up PD for short period when warm rebooting even
though the port is disable
Runtime V1.2.2.13; Loader V0.0.3.0
ES4528BH2-HPoE-0815-EC-00836
[TACACS] Since authorization is supported, it's not necessary to grant
privilege automatically after authentication.
ES4528BH2-HPoE-0815-EC-00832
[TACACS] Keep authentication behaviour.
ES4528BH2-HPoE-0815-EC-00827
Enter the “break” hotkey then switch will print out the “SysRq” message on
terminal..
ES4528BH2-HPoE-0815-EC-00825
MIB ,Getting the error while uploading in NNM
ES4528BH2-HPoE-0815-EC-00819
(MSTP_issue)MST configuration of spanning-tree is deleted by device after
reboot in v1.2.2.20
ES4528BH2-HPoE-0815-EC-00786
DAI works incorrectly with IPSG static binding
ES4528BH2-HPoE-0815-EC-00796
DHCPv6: After change IPV6 with dhcp mode from AutoConfig, DUT cannot
get DHCP ip address..
ES4528BH2-HPoE-0815-EC-00761
[XFER] Enhance XFER copy status message for UI.
ES4528BH2-HPoE-0815-EC-00731
[Enhance] ERPS with Multiple Instance
ES4528BH2-HPoE-0815-EC-00728
TWAMP prob and responder Support
ES4528BH2-HPoE-0815-EC-00643
[Enhance] SSH: Upgrade SSH to version 7.8p1
ES4528BH2-HPoE-0815-EC-00533
After LOIC-SSH attack, switch will lose management