User's Manual

Quick Start Guide

– 3 –

Note:

The number of available 2.4 GHz or 5 GHz external antenna connectors

depends on the specific model.

3. Connect Cables Connect outdoor-rated Ethernet cable to the 1000BASE-T RJ-45 ETH0 (PoE) port on

the unit.

4. Connect Power Install the PoE power injector indoors. Connect the power injector to the Ethernet

cable from the AP, to a port on a local LAN switch, and then to an AC power source.

Caution:

The power injector module is designed for indoor use only. Never mount

the power injector outside with the AP unit.

Attach External Antennas

Remove the front port cover by

pushing the locking tab up and then

sliding the cover off.

Connect external antennas to the

AP’s 5 GHz RP-SMA connectors using

RF coaxial cable provided in the

antenna package.

Connect external antennas to the

AP’s 2.4 GHz RP-SMA connectors

using RF coaxial cable provided in the

antenna package.

Connect outdoor-rated Category 5e

or better cable to the left-side RJ-45

ETH0 (PoE) port.

(Optional) Connect a local LAN

switch or computer to the right-side

ETH1 100BASE-TX RJ-45 port.

Pass the cables through the access

holes at the bottom of the AP.

Replace the port cover on the AP and

push the locking tab down to secure

it in place.