User's Manual

Chapter 24 | Wireless Interface Commands
– 208 –
Command Mode
Global Configuration
Example
AP(config)# interface wireless 0
Enter Wireless configuration commands, one per line.
AP(if-wireless 0)#
vap This command provides access to the VAP (Virtual Access Point) interface
configuration mode.
Syntax
vap <vap-index>
vap-index - The number that identifies the VAP interface.
(Options: 0-15)
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)#vap 0
AP(if-wireless 0: VAP[0])#
a-mpdu This command enables and sets the Aggregate MAC Protocol Data Unit
(A-MPDU).
Syntax
a-mpdu {enable | disable | length | <length >}
enable - Enable A-MPDU.
disable - Disable A-MPDU.
length - 1024-65535 bytes.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)