User's Manual

Chapter 24 | Wireless Interface Commands
– 219 –
Command Usage
◆ When enabled, the AP applies a priority order for associating clients when the
maximum clients for the VAP has been reached. The priority order is 11n clients,
11a/g clients, then 11b clients.
◆ When the association pool for the VAP is full and the AP receives an association
request from a high-priority (11n) client, the AP sends a disassociation to a
lower priority client (11a/g or 11b) in order to be able to associate the high-
priority client. If there are no lower-priority clients to disassociate, the AP will
reject the association request.
Example
AP(if-wireless 0: VAP[0])# client-assoc-preempt
set_vap_assoc_pri 0 0 y
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
assoc-timeout-
interval
This command configures the idle time interval (when no frames are sent) after
which the client is disassociated from the VAP interface.
Syntax
assoc-timeout-interval <minutes>
minutes - The number of minutes of inactivity before disassociation.
(Range: 5-60 minutes)
Default Setting
5 minutes
Command Mode
Interface Configuration (Wireless-VAP)
Example
AP(if-wireless 0: VAP[0])# assoc-timeout-interval 10
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#