8” Built-In Dishwasher BIDW1802SS / BIDW1802WH BIDW1802BL Owner’s Manual For more information on other great EdgeStar products on the web, go to https://www.edgestar.com To use the EdgeStar self-diagnostic tool, go to https://support.edgestar.com V1.
IMPORTANT SAFETY INFORMATION Read all instructions carefully prior to use. For your safety, the information detailed in this manual should be followed. Improper use and/or handling can cause serious damage to the appliance and/or to the user including but not limited to fire, explosion, and/or electric shock, resulting in personal injury, or death. This dishwasher is intended for domestic use only; any other use may invalidate the warranty.
General Safety • • • • • • • • • • • • • • • • • • • • • • • • Installation, maintenance and repair should be performed by a qualified installer. Work by unqualified persons could be dangerous and may void the warranty. This dishwasher should be properly installed and placed in a location in accordance with the Installation Instructions prior to operation. Do not attempt to repair or replace any part of your dishwasher unless it is specifically recommended in this manual.
Table of Contents IMPORTANT SAFETY INFORMATION ................................................................................................ I TABLE OF CONTENTS ...................................................................................................................... III FIRST TIME OPERATING INSTRUCTIONS ........................................................................................ 1 INTRODUCTION .......................................................................................
First Time Operating Instructions Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding the packaging materials. It is advised that you keep the original box and packaging materials in case you ever need to move or ship the appliance in the future. Introduction Thank you for purchasing this EdgeStar dishwasher.
Parts Identification Front View with Door Open 2
Front View with Door Closed Unpacking the Dishwasher • • • • • • Use at least two people to move and install the dishwasher to prevent injuries. Always lift the dishwasher to move it as sliding it can damage its base and feet, or floor surfaces. Carefully remove the packaging materials and inspect the dishwasher for damage. If the dishwasher is damaged immediately contact the dealer that sold you the product.
Features of Your New Dishwasher Multiple Filter System Your dishwasher has a Multiple Filter System. In the system there are three filters that can separate soiled water and clean water in different chambers. This Multiple Filter System improves your dishwasher’s performance with less water and energy use. Smart Wash System Your dishwasher also has a Smart Wash System. When a partial load of lightly soiled dishes is placed into the unit, a short wash cycle will automatically be performed.
Quick Start 1. Load the dishwasher (see Preparing and Loading Dishes section.) 2. Add detergent (see Filling the Detergent Dispenser.) 3. Add LIQUID rinse aid (see Filling the Rinse Aid Dispenser.) Rinse aid greatly improves drying and reduces water spots and film. The heated drying option will not perform as well without rinse aid. If the rinse aid is low or none is added the Status Display will show the error code “LSb.” 4. Close the door. 5.
• • • Status Display – If the Delay Start function is selected, the number of HOURS (H:01 – H:24) remaining in the delay time is shown. After a Wash Cycle is selected, the remaining time of the cycle is shown in hours and minutes (2:45 – END or -:--.) In certain situations that are critical to the dishwasher’s function and safe operation, the display may show error codes. If error codes are displayed, contact the dealer for help in trouble shooting the problem. See error codes on page 18.
Cycle Chart Note: The remaining time can suddenly increase or decrease by several minutes. This means the Smart Sensor has checked the soil level and determined if additional water fills need to be added or subtracted.
Preparing and Loading Dishes Dish Preparation Scrape away large pieces of food, bones, pits, toothpicks, etc. The continuously filtered wash system will remove the remaining food particles. Burned-on foods should be loosened before loading. Empty any liquids from glasses and cups. Foods such as mustard, mayonnaise, vinegar, lemon juice and tomato based products may cause discoloration of stainless steel and plastics if allowed to sit for a long period of time.
Loading the Upper Basket The upper basket is designed for glasses, mugs, cups, small plates, bowls and plastic items marked “dishwasher safe.” For best results, place the items with their soiled surfaces facing down or toward the center. Tilt slightly for better drainage. Adjusting the Upper Basket The upper basket can be raised to allow for dishes up to 11” in the lower basket.
Loading the Silverware Basket The silverware basket is divided into separate compartments (illustrated below) to allow for maximum cleaning efficiency. Spoons and forks should be placed in the basket with their handles pointing downward. Knives and other sharp utensils should be placed in the basket with their handles pointed upward. Longer utensils should be placed in the horizontal position on the upper basket’s cup shelf instead of in the silverware basket.
Forgot to Add a Dish? A dish can be added any time before the detergent dispenser opens: 1. Open the door slightly and wait several seconds for the wash cycle to stop. 2. You can open the door completely after the spray arms stop spinning. 3. Add remaining dishes. 4. Close the door. 5. Press the Start/Cancel button to continue the wash cycle. Caution: TO AVOID BURN INJURY: Slightly open the door and wait until the spray arms and wash action stop.
2. Add the recommended amount of dishwasher detergent to the main wash compartment. 3. Close the cap by sliding it forward and pressing down. Caution: • Use only detergent specifically made for use in dishwashers. • Do not use dish detergent designed for hand washing dishes as it will cause the dishwasher to overflow with suds.
Filling the Rinse Aid Dispenser The rinse aid is released during the final rinse to remove spots, prevent new film build-up on your dishes, glasses, flatware, cookware and plastic, and to improve drying time. Your dishwasher is designed to use ONLY LIQUID rinse aids. DO NOT use powdered rinse aids which will clog the dispenser and cause malfunctions. The rinse aid dispenser is located inside the door next to the detergent dispenser. 1. Open the rinse aid dispenser by lifting up the handle. 2.
4. Refill the rinse aid when the Status Display shows the “LSb” error code. Your dishwasher will run with low or no rinse aid, but your rinsing and drying results will suffer. Note: • Only use branded rinse aid, such as Jet-Dry, for the dishwasher. • Never fill the rinse aid dispenser with any other substances or detergents. Completing a Wash Cycle When the selected wash cycle has finished, the Status Display will read END, or -:-- if it has been canceled.
Dishwasher Maintenance Keeping your dishwasher clean improves its performance, reduces unnecessary repairs and lengthens its life. Cleaning the Exterior It is best to clean spills on the outside of your dishwasher as they occur. Use a soft, damp cloth on the control panel and door to gently wipe away spills and dust. Never use sharp objects, scouring pads, or harsh cleaners on any part of the dishwasher as they may scratch and discolor the surface of your dishwasher.
Removing, Cleaning and Replacing the Filter Assembly 1. Turn off the dishwasher. 2. Rotate the filter assembly counterclockwise to unlock it, then pull up to remove it. 3. Take apart the three filters by pulling the fine and course filters in opposite directions, then separate them from the main (flat) filter.
4. Remove all debris from the filters by rinsing them under warm, running water. You may loosen trapped particles with a soft bristled brush. 5. Once clean, reassemble the filters and place the entire filter assembly back into its compartment. Then, rotate the course filter clockwise until it locks into place and the arrows on the main filter and the course filter line up.
Cleaning the Lower Spray Arm The lower spray arm can be removed for periodic cleaning of the nozzles to prevent clogging and maintain the efficiency of your dishwasher. When removing the spray arm, exercise care so you don’t damage or break it. To remove, clean and replace the lower spray arm: 1. Visibly check whether the nozzle holes are clogged by soil or food particles. 2. If cleaning is needed, remove the spray arm by grasping it in the middle and pulling it upwards. 3.
Troubleshooting Error Codes Under certain conditions warning or malfunction codes will be shown on the Status Display. Error Code Meaning Possible Causes E1 Long water inlet time The water supply may not be opened or the water pressure may be too low. The water inlet may also be restricted or kinked. E3 Not reaching required temperature Possible heating element malfunction. E4 Overflow Dishwasher may be leaking or may have overflowed because of too much detergent or the wrong kind of detergent.
Troubleshooting Guide Issue Dishwasher does not start Water not pumped from dishwasher Dishwasher won’t fill Suds in tub Stained tub interior White film on dishwasher interior surface Rust stains appear on cutlery Knocking noise inside of dishwasher Possible Cause Fuse is blown or circuit breaker is tripped Power Supply is not connected or turned on Control panel lock is on Dishwasher door is not properly closed Previous cycle has not finished or has been interrupted Filter clogged Kitchen sink clogge
Issue Rattling noise inside of dishwasher Black or gray marks on dishes Detergent left in dispenser cup Possible Cause Item is not securely placed in dish rack Utensils may have rubbed against dishes Dishes are blocking detergent dispenser door Water hardness is too high Spots and filming on dishes Etching Dishes are not cleaned Cloudiness on glassware Pause the wash cycle and secure the items in the dish rack. Use a mild abrasive cleaner to eliminate marks. Load carefully.
Specifications Description of product 18” Built-In Dishwasher Model BIDW1802BL / BIDW1802SS / BIDW1802WH Color Black / Stainless Steel / White Number of Place Settings 8 Maximum Diameter of Place Settings 11" Voltage/Frequency 120V AC/60Hz Input Power Wash motor 100W, Heater 700W Delay Start 1-24 Hour Unit Dimensions HxWxD 32 1/2” x 17 5/8” x 22 7/16” Net Weight 52.9 lbs. Nominal Inlet Water Temperature 120°F Water Pressure 5.
EdgeStar Limited Warranty One (1) Year Parts & Labor This product is warranted by EdgeStar and is subject to any conditions set forth as follows: WHAT IS COVERED: For a period of ONE (1) YEAR from the date of original retail purchase, EdgeStar will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship.
