Manualshelf

Owner's Manual

ManualsBrandsEdgeStar ManualsAppliances52-Decibel Front Control 18-in Built-In Dishwasher (Black) ENERGY STAR
12345678910
5
Quick Start
1. Load the dishwasher (see Preparing and Loading Dishes section.)
2. Add detergent (see Filling the Detergent Dispenser.)
3. Add LIQUID rinse aid (see Filling the Rinse Aid Dispenser.) Rinse aid greatly improves drying
and reduces water spots and film. The heated drying option will not perform as well without
rinse aid. If the rinse aid is low or none is added the Status Display will show the error code
“LSb.”
4. Close the door.
5. Select the desired Wash Cycle (see Control Panel and Cycle Chart.)
6. Select the desired Options (see Control Panel.) The indicator light(s) next to the Options button
will glow when selected.
7. Run the hot water faucet nearest the dishwasher until the water is hot, then turn it off.
8. To Start, press Start/Cancel (see Control Panel.)
Control Panel
1. Wash Cycles
• Heavy – This cycle is for hard to clean, heavily soiled dishes, pots and pans.
• Normal – This is the standard cycle. It is for regularly soiled dinner dishes and silverware.
• ECO – Suitable for cleaning normally soiled tableware. This is the most efficient cycle in
terms of energy and water consumption.
• Glass – For lightly soiled loads such as glasses, crystal and china.
• Rapid – A shorter wash for lightly soiled loads that do not need drying.
• Rinse – Use for rinsing dishes, glasses and silverware that will not be washed right away.
2. Options
• Sanitize – This option maintains the water temperature at 156°F (69°C) max. The max
temperature may not be reached if the incoming water temperature is too low. The
Sanitize option is only available for Heavy, Normal and ECO cycles.
• Hi Temp – This option maintains the water temperature at 140°F (60°C) max. The Hi
Temp option is available for Heavy, Normal, ECO and Glass cycles.
• Heated Dry – When this option is selected the electric heater works during the drying
cycle. The Heated Dry option is available for all cycles except Rinse.
3. Additional Features
• Delay – To delay the start of a selected cycle, press the Delay button until the desired
delay time shows (in hours) on the display. You can delay the start for 1 to 24 hours.
Press Start/Cancel once to begin the delay timer. To cancel the delay start function before
the time period is over, press the Start/Cancel button again.