Use and Care Manual

 Status Display – If the Delay Start function is selected, the number of HOURS (H:01 –

H:24) remaining in the delay time is shown. After a Wash Cycle is selected, the remaining

time of the cycle is shown in hours and minutes (2:45 – END or -:--.) In certain situations

that are critical to the dishwasher’s function and safe operation, the display may show

error codes. If error codes are displayed, contact the dealer for help in trouble shooting

the problem. See error codes on page 18.

 Start/Cancel – Press to start a Wash Cycle or to start the Delay time. Press again to

cancel the cycle. When canceling a cycle the timer will count down from 60 seconds to

allow the unit to drain. If you want to Pause a cycle (e.g. to load additional plates), simply

open the door. WARNING - contents may be hot! Close the door and press start again to

continue the cycle.

 Control Panel Lock – To disable the Control Panel press and hold both the Options and

Delay buttons for 3 seconds (the lock indicator light will turn on.) To turn the Control Panel

back on press and hold both buttons for another 3 seconds (the lock indicator light will

turn off.)

4. Cycle Progress Indicator

 When Pre-wash, Main-wash, Rinse or Drying is lit the Wash Cycle is currently in that

stage.

 When the selected cycle is complete all indicator lights will be turned off and the display

will read END.