Use and Care Guide

Operation

Installation Check List Before Operation

1. Have all packing materials and tape been removed from the interior and exterior of the

Wine Cooler?

2. Have the installation instructions been followed, including connecting the machine to

electricity? And has proper grounding been installed for the Wine Cooler?

3. Has the machine been leveled?

4. Is the Wine Cooler in a site where the ambient temperature is between 50° F and 95° F

all year round?

5. Is there a clearance of at least 1- 2” at the rear, 1/4” at the top, and 1/4” at the sides for

proper air circulation?

Using the Temperature Control Panel

The single zone of this wine Cooler has a temperature range from 40°F to 65°F and

will display the set temperature.

 Up Button : Press the button on the control panel to increase the temperature by 1

degree increments.

 Down Button : Press the button on the control panel to lower the temperature by 1

degree increments.

 RUN LIGHT: When lit, the unit is in cooling mode

 Light Button : Press the button to turn the inner light on or off.

 Power Button : Turns the unit on and off. ( press and hold this button for approximately 3

seconds)

 The Celsius or Fahrenheit light will be lit depending on which temperature type is being

displayed. To switch between C and F. press and hold both buttons (▲/ ▼) simultaneously

for approximately 3 seconds. A beep will occur and the indicator light will illuminate next to

desired temperature setting.

Note:

 The Wine Cooler is equipped with a temperature memory function. If power is suddenly

lost, the previously set temperature will be saved and the Cooler will return to this setting

once power is restored.

 Allow at least 24 hours before storing your wines to allow the setting temperature to be

reached.