Owner's Manual

6
Installing the Door Handle
To install the door handle:
1. Remove the four screws from the side of the door. This should be the side opposite of the
door hinge.
2. Place and align the openings of the handle hinges over the screw holes.
3. Insert and tighten the screws to hold the handle in place.
Installing and Removing the Shelves
To prevent damaging the door gasket, make sure to open the door all the way before pulling
the shelves out of their track.
To Install the Shelves:
1. Open the door completely.
2. Slide the shelf on the shelf track and slowly push back until it stops.
3. Install the plastic notches.
To Remove the Shelves
1. Open the door completely.
2. If necessary, make sure you remove all the contents sitting on the shelf.
3. Remove both of the plastic notches with a screwdriver.
4. Continue to pull the shelf forward until it is completely removed from the inner
compartment.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless steel door.