Built-In Wine and Beverage Refrigerator CWB8420FD Owner’s Manual For more information on other great EdgeStar products on the web, go to http://www.edgestar.com To use the EdgeStar self-diagnostic tool, go to https://support.edgestar.com V2.
Important Safety Information Improper handling can cause serious damage to the EdgeStar wine refrigerator and / or injury to the user. This wine refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
General Safety • • • • • • • • • • • • • • • • • • • To prevent back and other types of injuries, use at least two people to move and install the wine refrigerator. This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by the person(s) responsible for their safety.
Table of Contents IMPORTANT SAFETY INFORMATION ....................................................................................................................I TABLE OF CONTENTS ..........................................................................................................................................III FIRST TIME OPERATING INSTRUCTIONS ........................................................................................................................4 INTRODUCTION...................
First Time Operating Instructions Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding the packaging materials. It is advised that you keep the original box and packaging materials in case you ever need to move or ship the appliance in the future. Let the unit stand for at least 24 hours before you use it; this allows the cooling components time to settle from transit.
Parts Identification Front View Tip: Gather the model and serial number from the product label and write them down before installing the wine refrigerator.
Installing the Wine Refrigerator The wine refrigerator should be installed in accordance with local electrical code requirements. The wine refrigerator should also be placed in a location that is strong enough to support its total weight, keeping in mind that it will weigh substantially more when fully loaded than when empty. Before you plug the wine refrigerator into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s oils to settle.
Installation Clearance Requirements Important Notes: • • • • Choose a location that has ambient temperatures above 50° F and below 95° F. Operation outside these temperatures may result in lowered efficiency or cause other adverse effects. This unit MUST be installed in an area protected from the elements, e.g. wind, rain, water spray or drips. The wine refrigerator should not be located next to ovens, grills, or other high heat sources.
Electrical Requirements ELECTRIC SHOCK HAZARD! • Plug into a grounded 3-prong outlet. • Never remove the grounding prong from the plug. • Never use an adapter to bypass the grounding prong. • DO NOT use an extension cord. • Failure to follow these instructions can result in fire, electrical shock, or death.
Installing the Door Handle To install the door handle: 1. Remove the door gasket (1). You can see two designated holes for handle installation. 2. Install the handle (4) tightly as shown above with two screws (3) and flat washers (2) provided. 3. Replace the door gasket. Caution: Do not over-tighten the screws as this may cause damage to the handle or to the stainless steel door.
To Remove the Shelves 1. 2. 3. Open the right door completely. If necessary, make sure you remove all the contents sitting on the shelf. Pull the shelf forward until the notch aligns with the plastic posts on each side of the shelf track. 4. 5. Lift the shelf until both notches pass through the posts. Continue to pull the shelf forward until it is completely removed from the inner compartment. Reversing the Door Swing Follow the instructions below to reverse the door swing.
2. Remove the bottom hinge plate (5) by unscrewing the four lock screws (6). Be careful to hold the glass door firmly after removing the screws. 3. Gently pull down to remove the glass door (12) from the right top hinge and place it on a padded surface to avoid the risk of damage. Then, remove the right top hinge (7) by unscrewing the screws (8). 4. Unscrew and transfer the hinge pin on the bottom hinge plate (5) to the opposite side.
5. Pop out the cover caps on the left side of cabinet and use them to cover the screw holes on the right hand side. 6. Screw the alternate left top hinge (9), included in the fittings, on the left hand side of cabinet. 7. Unscrew and transfer the lock bracket (11) to the opposite side of the glass door. Then use the cover (10) included in the fittings to cover the three holes left after unscrewing the lock bracket. 8. Rotate the door 180° and relocate to the designated position.
Using the Temperature Control Panel Lower Zone Upper Zone Each zone is independently controlled by the touchpad controls located on the center divider (pictured above). The temperature display can be in Fahrenheit or Celsius. The top (beverage) zone has a temperature range from 41°F to 68°F. The bottom (wine) zone has a temperature range from 36°F to 43°F. • Increase Button : Press the button on the control panel to increase the temperature by 1 degree increments.
Advanced Functions Sabbath Mode This unit is equipped with Sabbath mode for the observance of religious holidays. This mode turns off the display, interior light and the alarm. To enable Sabbath mode, press and hold the and buttons for five (5) seconds. The indicator light will flash four (4) times, confirming that the unit is now in Sabbath mode. The unit will exit Sabbath mode automatically after 96 hours or the user can once again press and hold the power and light buttons for five (5) seconds.
Defrosting The wine refrigerator will automatically defrost under most temperature settings and ambient conditions. However, on colder settings, some frost may build up. Additionally, under more humid ambient conditions, more frost may build up. Keep the door closed as much as possible and avoid opening the door unnecessarily to minimize frost build-up. If frost is preventing the door from closing properly, you may need to power the unit off until the frost melts. Use a soft absorbent towel to dry the unit.
Cleaning and Maintenance Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. Exterior Cleaning The door and cabinet may be cleaned with a mild detergent and lukewarm water solution. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting. If the door panel is stainless steel, it can discolor when exposed to chlorine gas and moisture.
Troubleshooting Before Calling for Help If the unit appears to be malfunctioning, read through the “Operation” section of this manual first. If the problem persists, check the Troubleshooting Guide below and on the following page. The problem may be something that can easily be solved or explained. Symptoms The wine refrigerator turns on and off frequently. Possible Causes The room temperature is higher than the recommended ambient environment. The door is being opened too often.
Symptoms The body of the wine refrigerator is electrified. Possible Causes The unit is not grounded properly. Frost is forming in the wine refrigerator. The environment is humid. The ambient temperature is too low. The door is being opened too frequently. The door will not shut properly. The refrigerator is not level. The door gasket is dirty. The door gasket is not installed correctly. The shelves are incorrectly installed.
Specifications Note: Technical data and performance information are provided for reference only. Specifications are subject to change. Check the rating label on the wine refrigerator for the most accurate information. Description of product Built-in Wine and Beverage Cooler Model CWB8420DZ Voltage / Frequency AC 115V~60Hz Amperage 1.0A Input Power 100W Color Black Cabinet; Stainless Steel Door Storage Capacity 22 Bottles*, 84 standard 12oz. cans Refrigerant R600a, 0.99 oz.
Edgestar Limited Warranty Full One-Year Parts and Labor WHAT IS COVERED: This product is warranted by EdgeStar and is subject to any conditions set forth as follows: For a period of ONE (1) YEAR from the date of original retail purchase, EdgeStar will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship.
