Owner's Manual

9
Installing the Door Handle
To install the door handle:
1. Remove the door gasket (1). You can see two designated holes for handle installation.
2. Install the handle (4) tightly as shown above with two screws (3) and flat washers (2)
provided.
3. Replace the door gasket.
Installing and Removing the Shelves
To prevent damaging a door gasket, make sure to open the door all the way before pulling the
shelves out of their track.
To Install the Shelves:
1. Open the door completely.
2. Slide the shelf onto the shelf track and slowly push it back until it stops.
3. Push down on the front of the shelf to allow the back of the shelf to lift over the plastic
post. (Imagine a seesaw movement.) Continue to push the shelf back until both
notches pass through the plastic posts on each side of the shelf track.
4. Continue to push the shelf back.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless steel door.