Ed3¢Star ° Built-in Wine Refrigerator CWR361FD Owner's Manual For more information on other great EdgeStar products on the web, go to http://www.edgestar.
Important Safety Information Improper handling can cause serious damage to the EdgeStar wine refrigerator and/or injury to the user. This wine refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
Table of Contents IMPORTANT SAFETY INFORMATION ................................................................. INTRODUCTION ................................................................................................... PARTS IDENTIFICATION ..................................................................................... BACK VIEW .......................................................................................................... FRONT VIEW .................................................
Introduction Thank you for purchasing this EdgeStar wine refrigerator. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship. This manual contains important information regarding the proper installation, use and maintenance of your wine refrigerator. Following this manual will ensure that your product will work at its peak performance and efficiency.
Parts Identification Control Panel Front View Carbon Filter Internal Fan Shelf Door Handle Note: The carbon filter should be replaced every 3-6 months depending on the unit's exposure level to odor. If the unit is placed in the kitchen regular replacement every 3 months is ideal. Lock Front vent Leveling foot Back View Product Label Tip: Gather the model and serial number from the product label and write them down before installing the wine refrigerator.
Installing the Wine Refrigerator The wine refrigerator should be installed in accordance with local electrical code requirements. The wine refrigerator should also be placed in a location that is strong enough to support its total weight, keeping in mind that it will weigh substantially more when fully loaded than when empty. Before you plug the wine refrigerator into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor's oils to settle.
Installation Clearance Requirements When installing the wine refrigerator under a counter, recommended spacing dimensions shown. follow the • To ensure proper service access and ventilation, allow at least 2/5" clearance at the back, 1/5" at top and 1/5" at sides. The installation should allow the unit to be pulled forward for servicing, if necessary. Important • Choose Top View Notes: a location that has Back of unit ambient temperatures above 50°F and below 95°F.
Electrical Requirements ELECTR|C SHOCK HAZARD! • Plug into a grounded • Never remove • • Never use an adapter to bypass the grounding DO NOT use an extension cord. • Failure to follow electrical 3-prong the grounding outlet. prong from the plug. these instructions prong. can result in fire, shock, or death.
Installing the Door Handle To install the door handle: 1. Open the door and carefully pull the door gasket where the handle is to be installed. around the area 2. Carefully remove the two pre-installed decorative plugs from the front of the door. Note: some wine coolers do not have decorative plugs installed. 3. Insert each Phillips head screw through the gasket side of the door until the screw pass through the door. 4.
OPERATION Note: Whether your wine cooler can reach the actual set temperature depends on the ambient environmental conditions. Using the Temperature Control Panel Use the left button to adjust the button to adjust the right zone's can be in Fahrenheit or Celsius. range from 40°F to 65°F for the left zone's temperature, and use the right temperature.
Normal Sounds Your new wine refrigerator may make sounds that are not familiar to you. Most of the new sounds are normal. Hard surfaces like the floor, walls can make the sounds seem louder than they actually are. The following describes the kinds of sounds that might be new to you and what may be making them. • Rattling noises may come from the flow of the refrigerant or the water line, Items stored on top of the wine refrigerator can also make noises.
CLEANING AND MAINTENANCE Periodic cleaning and proper maintenance performance, and long life. Exterior will ensure efficiency, top Cleaning The door and cabinet may be cleaned with a mild detergent and lukewarm water solution such as 2 tablespoons of baking soda to 1 quart of water. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting.
Troubleshooting Issue The wine cooler does not turn on. The wine cooler will not reach the desired temperature con tinued Possible cause Solution There is a power failure. Ensure the cooler is plugged in and the power outlet has power. The cooler is not plugged in. Plug the unit in to a power outlet that has sufficient amperage. A house fuse has blown or the circuit breaker is tripped. Replace the broken fuse in your fuse box or reset the breaker. The cooler is placed too close to a heat source.
Specifications Description of product Built-in Wine Refrigerator Model CWR361FD Voltage/Frequency AC 115V~60Hz Amperage 1.2A Input Power 120W Color Black Cabinet; Doors Storage Capacity Refrigerant Temperature Steel 36 Bottles* R134a, 2.12 oz. Range Dimensions (Height Stainless 40 - 65°F (Both Zones) 34 1/8" x 23 1/2" x 24 318" x Width x Depth ) Weight Note: Technical reference only.
This product is warranted by EdgeStar and is subject fo any conditions WHAT IS COVERED: WHAT IS NOT COVEREDcoverage For a period of ONE (1) YEAR from the date of original retail purchase, EdgeSfar will repair or replace any part free of charge including that fails due fo a defect in materials or labor workmanship. Labor will be performed free of charge at an authorized EdgeStar repair facility and EdgeStar will supply new, rebuilt, or refurbished parts free of charge.
@ EdgeStar Products 500 N. Capital of TX Hwy, Bldg 5 Austin, TX 78746 Toll Free: 1-866-319-5473 Web: http://www.edgestar.com E-mail: service@edgestar.com Register your product, download owner's manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar products on the web at: http://www.edgestar.com Product contents Copyright and specifications © 2011 Living may change without notice. Direct, Inc. All rights reserved.
