Use and Care Guide

EdgeStar Wine Refrigerator 6
Installing the Door Handles
To install a door handle:
1. Open the door and carefully pull back the door gasket around the area
where the handle is to be installed.
2. Insert each Phillips head screw through the gasket side of the door
until the screw passes through the door.
3. Align the handle with the screws and tighten using a Phillips head
screwdriver until the handle is flush against the door frame.
CAUTION: Do not over-tighten the screws as this may cause damage to
the handle or to the stainless steel door
4. Carefully press the door gasket into its original position.
5. Repeat for next door.
Installing and Removing the Shelves
To prevent damaging a door gasket, make sure to open each door all the
way before pulling the shelves out of their track.
To install the shelves:
1. Open the door completely.
2. Identify the protective stoppers located on the right and left sides of the
back of each wood wine shelf.
3. Lift either the left or right side of the shelf creating a 45° angle. Insert
the shelf at the desired track level and push back slowly until it stop in
place.
4. Gently set the shelf down in place; it should be level.
To remove the shelves:
1. Open the door completely.
2. Make sure the shelf is pushed back completely (towards the rear wall).
3. If necessary, make sure you remove all the contents sitting on the
shelf.
4. Identify the protective stoppers located on the right and left sides of the
back of each wood wine shelf.
5. Lift either the left or right side of the shelf creating a 45° angle from its
original position. Make sure not to lift either side of the shelf too hard as it
may come in contact with the inner wall mount
6. Pull the shelf forward until it is completely removed from the inner
compartment. Set aside safely.