Owner Manual

Important: Do not remove any safety, warning, or product information labels from your

beverage refrigerator.

Warning: Do NOT install the beverage refrigerator built-in or behind a closed cabinet door.

Warning: Use two or more people to move and install the beverage refrigerator. Failure to do

so can result in back or other injury. Carefully remove the packaging materials. Remove any

shipping tape and glue from your beverage refrigerator before use. Do not use sharp

instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.

These products can damage the surface of your beverage refrigerator.

Installing the Beverage Refrigerator

The beverage refrigerator should be installed in accordance with local electrical code

requirements. The beverage refrigerator should also be placed in a location that is strong enough

to support its total weight, keeping in mind that it will weigh substantially more when fully loaded

than when empty. Before you plug the beverage refrigerator into a power supply, be sure to

let it stand upright for at least 24 hours to allow the compressor’s oils to settle.

Unpacking the Beverage Refrigerator

Installation

This beverage refrigerator has been designed for freestanding installation. There must be

adequate ventilation and access for service.

Freestanding Installation:

A freestanding installation will allow you to install the beverage refrigerator in almost any

place you desire as long as there is proper ventilation. This product is not designed to be

built into a cabinet or recessed setting. You must follow the stated instructions for electrical

requirements and leveling the beverage refrigerator.

• Choose a location that has ambient temperatures above 50° F and below 90° F.

Operation outside these temperatures may lead to lowered efficiency or other adverse

effects.

• This unit MUST be installed in an area protected from the elements, e.g., wind, rain,

water spray or drips.

• The beverage refrigerator should not be located next to ovens, grills, or other high heat

sources.

• Do not kink or pinch the power supply cord between the beverage refrigerator and the

wall or cabinet.

• The beverage refrigerator should be installed on a firm and level surface that will be

able to support the entire weight of a fully loaded unit. It is important for the beverage

refrigerator to be level in order to work properly. If needed, you can adjust the height

of the beverage refrigerator by rotating the feet. See the “Leveling the Beverage

Refrigerator” section.

• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance

with National Electrical Code and local codes and ordinances, is required.