Owners Manual
Table Of Contents
- Important Safety Information
- Gas and Electrical Safety
- First-Time Operating Instructions
- Introduction
- Parts Identification
- Grill Dimensions
- Island / Cabinet Cutout Dimensions
- Maintaining Adequate Ventilation
- Unpacking the Gas Grill
- Installing the Gas Grill
- Checking for Gas Leaks
- Electrical Requirements
- Included Cooking Components
- Operation
- Cleaning and Maintenance
- Cart Dimensions
- Cart Assembly Instructions
- Specifications
- EdgeStar Limited Warranty
32
Lighting the Burner(s)
1. Make sure you have observed all safety warnings in this manual. Follow the instructions for
parts as far away from the grill as possible. Never smoke while lighting the grill.
2. Open the grill hood.
3. With all gas control (burner) knobs in the OFF position, open the gas supply.
4. For each burner you wish to operate, push the gas control (burner) knob in, and rotate
counterclockwise to the “High” position marking on the knob.
5. The Piezo-style ignition system will create a loud clicking noise as it produces a spark to ignite the
6.
residue.
7. Open the lid and adjust the burner knobs to your desired cooking temperature.
If the burners fail to light:
1.
2.
outlined above.
3.
needed.
4. If, after a few rounds of trying to light the burner using the Piezo-style ignition, the burner still does
not light consider using the manual ignition method in the following section.
5.
6.
“Flashback” may occur in or around the burner tubes. Flashback is commonly recognized by a
grill. Allow grilling components to cool fully before handling them. Remove the burners and brush
reinstall them after they have been thoroughly cleaned.