Owner's Manual

10
Note: Before you begin, unplug the ice maker or disconnect the power.
Reversing the Door Swing
!
Step 1: Disassembly
• Start by removing the hinge cap covers that are located
on the top of the cabinet on the side of the unit where
the door is going to be installed.
• Next, pry o󰀨 the upper hinge cover plate with your
ngers or a at head screwdriver being careful not to
scratch the surface of the cabinet.
• Remove the Phillips head screws (2) that are securing
the upper hinge in place.
• While holding door in closed position, remove the
upper hinge and hinge gasket.
• Lift door upwards and remove, set aside.
Step 2: Reverse Lower Pivot Hinge
• Remove the lower pivot hinge cover screw
• Remove lower pivot plate and pivot hinge
• Insert lower pivot hinge and pivot plate on side of
cabinet where door to be installed.
• Install pivot hinge screw cover on opposite side.
Step 3: Re-Install Door
• Insert upper hinge caps on upper cabinet side where
door no longer installed.
• Align left side of door with bottom pivot hinge and slide
into place while holding door upright at a 90° angle to
avoid damaging the door or lower pivot hinge.
• Align hinge gasket and upper hinge over hinge
mounting holes and secure with 2 screws making sure
to slide door hinge pin into top of door frame.
NOTE: Use the hinge screw holes that correspond to the
side of the cabinet on which the door is being installed.
Left holes for left side installation, right holes for right side
installation.
• Secure hinge into ice maker cabinet with 2 screws.
• Slip hinge cover over upper hinge and snap into place.