Owner's Manual

15
Issue
Possible Cause
Solution
The machine won't operate.
The icemaker is unplugged.
Plug the ice maker in.
The fuse is blown.
Replace the fuse.
The icemaker power switch is
OFF.
Switch the ice maker power
switch to ON.
The ice storage bin is full of ice.
Take away some ice cubes;
make sure the ice-full probe is
free of ice.
The water doesn't feed in after
the ice maker starts.
The water supply tap is turned
off.
Turn on the water supply tap.
The water supply pipe is not
properly connected.
Reconnect the water supply
pipe.
The machine makes ice, but
the bin does not fill up with ice.
The condenser may be dirty.
Clean the condenser.
The air flow to the ice maker
may be obstructed.
Check the installation.
The ambient temperature and
water temperature are high, or
the unit is close to a heat
source.
Check the installation.
Water is leaking out of the unit.
A few water droplets are on the
door.
Under some conditions,
humidity may condense on the
door. Consider moving the unit
or just be more careful when
you open the door.
The water supply connection is
leaking.
Tighten the fitting. See the
“Connecting the Water Line”
section.
Major Functions
1. This unit runs a completely automatic operation.
2. The different colors of the LED display indicate various operating modes.
3. The fan motor responds to the ambient temperature. If it is cold, the motor will stop working to
keep the cooling system in good working condition.
4. Ice cube size is adjustable.
5. A sensitive probe and accurate timer enhance the performance of the ice maker.
6. There is a built-in compressor protection system.
Troubleshooting
Before Calling for Service
If the unit appears to be malfunctioning, read through the “Operation” section of this manual first. If
the issue persists, check the troubleshooting section below and on the following page. The issue
could be solved by following the suggestions in the “Solution” column.