Manual

TROUBLESHOOTING
Before Calling for Service
If the unit appears to be malfunctioning, read through the
OPERATION section of this manual first. If the issue persists,
check the troubleshooting section below. The issue could be solved
by following the suggestions in the "Solution" column.
Issue Possible Cause Solution
The machine won't The icemaker is unplugged. Plug the ice maker in.
operate. The fuse is blown. Replace fuse.
The icemaker power switch is Turn the ice maker power switch to ICE
OFF. (ON)
The ice storage bin is full of ice. Take away some ice cubes; make the ice-
full probe is free of ice.
The water doesn't Turn on the water supply tap.
feed in after the ice Reconnect the water supply pipe.
maker starts.
Machine makes Clean the condenser.
ice, but bin does Check the installation.
not fill up with ice
Check the installation.
Water is leaking
out the unit.
Cubes are partially
formed--are white
at the bottom.
Noise during
operation
The icemaker
stops suddenly
while making ice.
The water supply tap is turn off.
The water supply pipe is not
proper connected.
The condenser may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature and
water temperature are high, or it
is near with some heat source.
A few water droplets are on the
door.
The water supply connection is
leaking.
Not enough water in the water
bin.
The feet are not leveled and
locked
Certain sounds are normal.
The electricity is off.
The room temperature is out of
the stated range.
The body of the ice The ground line isn't in the
maker is electrified socket.
Scale builds up The calcium level in the water is Use a water-softening apparatus installed
quickly inside the too high. in front of the water inlet valve.
machine.
Under some conditions, humidity may
condense on the door. Consider moving
the unit or just be more careful when you
open the door.
Tighten fitting. See "Connecting the water
line".
Check if the water supply pressure is
below 0.05Mpa.
Check water supply--filter may be
restricted.
Check for a water leak at the water trough.
Level and lock the feet. See Leveling the
Ice Maker.
See "Normal Sounds."
Reconnect the power supply line.
Cut off the electricity and let the ice maker
stop working until the temperature returns
within the stated range.
Use the correct plug and outlet.
EdgeStar Full Size Ice Maker 16