Ice Maker IF80SS Owner’s Manual For more information on other great Edgestar products on the web, go to http://www.edgestar.
Important Safety Information Improper handling can cause serious damage to the Edgestar ice maker and/or injury to the user. This ice maker is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
Table of Contents IMPORTANT SAFETY INFORMATION ................................................................. I INTRODUCTION ................................................................................................... 1 PARTS IDENTIFICATION ..................................................................................... 2 BACK VIEW .......................................................................................................... 2 FRONT VIEW ...........................................
Introduction Thank you for purchasing this Edgestar ice maker. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship. This manual contains important information regarding the proper installation, use and maintenance of your ice maker. Following this manual will ensure that your product will work at its peak performance and efficiency.
Parts Identification Front View 4 1 Control Panel Air Outlet 2 5 3 Drain Plug 6 7 Back View 9 # 1 2 3 4 5 6 7 8 9 10 11 Ice Maker Part Power Switch Ice Maker Door Air Outlet Display Panel Ice Level Sensor Ice Storage Container Ice Scoop Bottom Floor Feet Power Cord Water Inlet Valve Drainage Tube 10 8 Edgestar Portable Ice Maker 11 2
Before you Begin: Preparing the Ice Maker for Use Before you plug the ice maker in to a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s oils to settle. Unpacking the Ice Maker IMPORTANT: Do not remove any safety, warning, or product information labels from your ice maker. Carefully remove the packaging materials. Remove any shipping tape and glue from your ice maker before using.
Operation Using Your Ice Maker Before using your ice maker it is strongly recommended to clean it thoroughly. Read and follow the Cleaning and Maintenance section of the manual before proceeding. Follow the steps below to start using your ice maker. IMPORTANT: Discard the first batch of ice produced by the portable ice maker. CAUTION: Direct sunlight may cause the ice full infrared sensor to malfunction.
How the Portable Ice Maker Produces Ice After the unit is powered on, the ice maker begins with rotating the ice case into a horizontal water fill position under the evaporator rods. The water pump is engaged and fills the ice case with water. Water overflows for a few seconds before the compressor turns on. The compressor then pumps refrigerant and the fan will turn on automatically after the condenser heats up. The unit will be producing bulet shaped ice around the stainless steel evaporator rods.
Installing the Water Line The direct water line can be easily installed into the ice maker for a continuous flow of water, preventing you from refilling a water tank every time you need more ice. Here is how you would install the water line: 1. Connect the water line to your water source and be sure to tighten the connection to avoid leaking. 2. Hand screw the water line into the water inlet valve on the back of the ice maker. 3. Connect the drainage tube on water outlet valve. 4.
CLEANING AND MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. Never use a solvent-based cleaning agent. These cleaners may transmit taste to the ice cubes, or damage and discolor the interior. The icemaker must be thoroughly cleaned if it has been left unused for a long time. Follow carefully any instructions provided for cleaning or use of sanitizing solution. Do not leave any solution inside the icemaker after cleaning.
TROUBLESHOOTING Before Calling for Service If the unit appears to be malfunctioning, the issue could be solved by following the suggestions in the “Solution” column. Issue Possible Cause Solution The ice maker is unplugged. Plug the ice maker in. Press the power button. The Power Indicator light should be on. Try a different power outlet. If the unit works on a different circuit, you may need to contact a certified electrician to resolve the power issue.
Specifications Description of product Portable Ice Maker Model IF80SS Voltage/Frequency AC 115V~60Hz Ice-Making / Ice-Harvest rated current 1.2A / 3.5A Color Silver Ice Storage capacity 7.7 lbs Ice-making capability 44 lbs/ day * Refrigerant R134a, 3.4oz Dimensions (Width x Depth x Height) 14 7/8” x 18 13/16” x 23 3/16 Weight 60 lbs Note: Technical data and performance information provided for reference only. Specifications are subject to change.
Limited Warranty One (1) Year Parts & Ninety (90) Days Labor This product is warranted by EdgeStar to be free from defective workmanship and materials, subject to any conditions set forth as follows: WHAT IS COVERED: LABOR: For a period of NINETY (90) DAYS from the date of original purchase, labor will be performed free of charge at an authorized EdgeStar repair facility.
EdgeStar Products 500 N. Capital of TX Hwy, Bldg 5 Austin, TX 78746 Toll Free: 1-866-319-5473 Web: http://www.edgestar.com E-mail: service@edgestar.com Register your product, download owner’s manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar products on the web at: http://www.edgestar.com Product contents and specifications may change without notice. Copyright © 2011 Living Direct, Inc. All rights reserved.