Assembly Guide

ManualsBrandsEdgeStar ManualsAppliancesSingle Tap 18 in. 1/6 Barrel Beer Keg Dispenser in Stainless Steel

KC1000 Kegerator Installation Guide

1. Faucet Handle

2. Beer Tower

3. Drip Tray

4. CO

2 Regulator

5. CO

2 Tube

6. CO

2 Cylinder (supplied empty)

7. American Sankey Keg Coupler

8. Sixth Barrel (not included)

9. Beer Line

10. Neoprene Washer

11. Hose Clamp

12. Tower Plug

13. Tower Gasket

14. Screws (4)

Tools Needed:

- Wrench

- Flat Head Screwdriver

- Pair of Pliers/Clamp Crimper

*Additional replacement parts may be included

For additional information

visit edgestar.com

Summary of content (4 pages)

PAGE 1
KC1000 Kegerator Installation Guide 1 2 3 10 11 9 7 4 12 13 6 14 5 8 1. 2. 3. 4. 5. 6. 7. Faucet Handle Beer Tower Drip Tray CO2 Regulator CO2 Tube CO2 Cylinder (supplied empty) American Sankey Keg Coupler *Additional replacement parts may be included 8. Sixth Barrel (not included) Tools Needed: - Wrench 9. Beer Line - Flat Head Screwdriver 10. Neoprene Washer - Pair of Pliers/Clamp Crimper 11. Hose Clamp 12. Tower Plug 13. Tower Gasket 14. Screws (4) For additional information visit edgestar.
PAGE 2
1 Power On 2 Carefully remove the tower plug (#12) located on the top of the unit by opening the cabinet, and with your hand, push plug through the top of the cabinet from the inside. Use flat head screwdriver as a prying tool if necessary. Ensure the power light is on and set the thermostat using the (+) and (-) buttons to the desired temperature. The recommended temperature setting is 36 degrees Fahrenheit. NOTE: Temperature settings can vary depending on beer type, ambient temperature and preference.
PAGE 3
7 Connect Beer Line to Coupler Remove the rubber cap from the top of the coupler. Place the neoprene washer (#10) located under the rubber cap to the top of the coupler (#7). Take the hex nut from the end of the beer line (#9) and screw it onto the top of the keg coupler so that the neoprene washer is between it. 9 8 Tap the Keg To connect the keg coupler (#7) to the keg (#8), first make sure the black pull handle of the keg coupler is in the up position (45° angle).
PAGE 4