BR1000SS Fridge for the KC1000 Kegerator Owner’s Manual For more information on other great EdgeStar products on the web, go to http://www.edgestar.
Important Safety Information Improper handling can cause serious damage to the EdgeStar kegerator and/or injury to the user. This kegerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
Table of Contents IMPORTANT SAFETY INFORMATION ................................................................. I INTRODUCTION ................................................................................................... 1 PARTS IDENTIFICATION ..................................................................................... 2 BACK VIEW .......................................................................................................... 2 FRONT VIEW ...........................................
Introduction Thank you for purchasing this EdgeStar kegerator. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship. This manual contains important information regarding the proper installation, use and maintenance of your kegerator. Following this manual will ensure that your product will work at its peak performance and efficiency.
Parts Identification Front View Top Cover Internal Fan Opening for Dispense Tower Switch for Internal Light Control Panel Cold Plate Recessed Handle Door Leveling Foot Compressor Step Tip: Gather the model and serial number from the product label and write them down before installing the kegerator.
NOTE: This appliance is designed for “indoor” use only and should not be used outdoors. PROPER LOCATION To ensure the kegerator will last, install it in a location where there is proper air circulation and electrical connections. Keep the refrigerator away from heat and direct sunlight. This refrigerator is designed for indoor use only and should not be used outdoors. It should not be placed in a built-in or recessed area as it is designed to be a freestanding kegerator.
It is recommended that a separate circuit, serving only your kegerator, be provided. Use receptacles that cannot be turned off by a switch or pull chain. The fuse (or circuit breaker) size should be 15 Amps. Recommended grounding method For your personal safety, this appliance’s plug must be grounded. It is equipped with a 3-prong power supply cord.
OPERATION Installation Check List before Operation Note: Allow the refrigerator to stand in an upright position for 24 hours before turning on the power. This will ensure that the coolant has settled. 1. Have all packing materials and tape been removed from the interior and exterior of the kegerator? 2. Have the installation instructions been followed, including connecting the machine to electricity? And has proper grounding been installed for the kegerator? 3. Has the machine been leveled? 4.
Normal Sounds Your new kegerator may make sounds that are not familiar to you. Most of the new sounds are normal. Hard surfaces like the floor or walls can make the sounds seem louder than they actually are. The following describes the kinds of sounds that might be new to you and what may be making them. Rattling noises may come from the flow of the refrigerant or the water line. Items stored on top of the kegerator can also make noises.
Exterior Cleaning The door and cabinet may be cleaned with a mild detergent and lukewarm water solution such as 2 tablespoons of baking soda to 1 quart of water. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting. If the door panel is stainless steel, it can discolor when exposed to chlorine gas and moisture. Clean stainless steel with a cloth dampened with a mild detergent and warm water solution.
Troubleshooting continued Issue The kegerator does not turn on. The kegerator will not reach the desired temperature Possible cause Solution There is a power failure. Ensure the unit is plugged in and the power outlet has power. The unit is not plugged in. Plug the unit in to a power outlet that has sufficient amperage. A house fuse has blown or the circuit breaker is tripped. Replace the broken fuse in your fuse box or reset the breaker. The unit is placed too close to a heat source.
Specifications Description of product Freestanding Kegerator Model BR1000SS Fridge for the KC1000 Kegerator Voltage/Frequency AC 115V~60Hz Amperage 1.2A Color Black Cabinet; Stainless Steel Door Storage Capacity Options 1 Sixth Barrel Keg or 1 Cornelius Keg Refrigerant R600a Dimensions (Height x Width x Depth ) 20.1" x 17.52" x 32.72" Weight 63.8 pounds Note: Technical data and performance information is provided for reference only. Specifications are subject to change.
EdgeStar Limited Warranty One (1) Year Parts & Ninety (90) Days Labor This product is warranted by EdgeStar to be free from defective workmanship and materials, subject to any conditions set forth as follows: WHAT IS COVERED: LABOR: For a period of NINETY (90) DAYS from the date of original purchase, labor will be performed free of charge at an authorized EdgeStar repair facility.
EdgeStar Products 500 N. Capital of TX Hwy, Bldg 5 Austin, TX 78746 Toll Free: 1-866-319-5473 Web: http://www.edgestar.com E-mail: service@edgestar.com Register your product, download owner’s manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar products on the web at: http://www.edgestar.com Product contents and specifications may change without notice. Copyright © 2015 Living Direct, Inc. All rights reserved.