Installation Sheet

ManualsBrandsEdgeStar ManualsAppliancesSingle Tap 15 in. 1/4 Barrel Beer Keg Dispenser with Forced Air Refrigeration and Air Cooled Beer Tower in Black

KC7000 Kegerator Installation Guide

1. Faucet Handle

2. Faucet

3. Beer Tower

4. Guard Rail

5. Drip Tray

6. Regulator

7. CO

2 Tube

8. CO2 Cylinder (supplied empty)

9. Cylinder Strap

10. American Sankey Keg Coupler

11. Metal Keg Floor Support

12. Casters (x4)

13. Beer Line

14. Half Barrel Keg (not included)

15. Neoprene Washer

16. Hose Clamps (2)

17. Spanner Wrench

18. Tower Plug

19. Rail Post (4)

20. Tower Gasket

21. Rail Screws (4)

22. Tower Screws (4)

Tools Needed:

- Wrench

- Flat Head Screwdriver

- Pair of Pliers/Clamp Crimper

For additional information

visit edgestar.com

Summary of content (4 pages)

PAGE 1
KC7000 Kegerator Installation Guide 1 15 2 3 4 16 5 17 6 10 18 9 13 19 8 7 11 20 14 12 21 22 1. 2. 3. 4. 5. 6. 7. Faucet Handle Faucet Beer Tower Guard Rail Drip Tray Regulator CO2 Tube 8. CO2 Cylinder (supplied empty) 9. Cylinder Strap 10. American Sankey Keg Coupler 11. Metal Keg Floor Support 12. Casters (x4) 13. Beer Line 14. Half Barrel Keg (not included) Tools Needed: - Wrench - Flat Head Screwdriver - Pair of Pliers/Clamp Crimper 15. 16. 17. 18. 19. 20. 21. 22.
PAGE 2
1 Install Caster Wheels Before assembly, make sure to empty the inside of the unit. Carefully lay the unit on its back. Remove the legs and screws around the legs. Attach the casters (#12) into the existing holes at the bottom of the unit using previously removed screws. Then carefully set the unit back upright. 2 Remove Plug Carefully remove the top tower plug (#18) located on the top of the unit by opening the cabinet, and with your hand, push plug through the top of the cabinet from the inside.
PAGE 3
7 Connect Regulator to Cylinder Attach the CO2 regulator (#6) to the CO2 cylinder (#8) by screwing the regulator nut onto the cylinder valve and tightening with pliers. Note: A fiber washer is normally required to connect a regulator to a CO2 cylinder, but the standard regulator provided includes a built-in o-ring. 9 Mount CO2 Cylinder Place the CO2 cylinder (#8) on the step and secure with the cylinder strap (#9). 11 Connect Beer Line Now connect the beer line (#13) to the keg coupler (#10).
PAGE 4
13 Calibrating the Regulator (A) With the shut-off valve on the regulator (#6) closed, open the valve on the CO2 cylinder (#8) completely. (B) Pull the gray regulator knob towards you to unlock the adjustment knob if it does not turn freely. (C) Slowly turn the knob clockwise until the desired pressure is shown on the pressure gauge on the top. By turning the knob clockwise it will increase (+) pressure and counterclockwise will decrease (-) pressure.