Install Manual

ManualsBrandsEdgeStar ManualsAppliancesSingle Tap 20 in. Full Size Beer Keg Dispenser in Stainless Steel

KC2000 Kegerator Installation Guide

1. Faucet Handle

2. Faucet

3. Beer Tower

4. Guard Rail

5. Drip Tray

6. CO2 Regulator

7. CO

2 Tube

8. CO

2 Cylinder (supplied empty)

9. Cylinder Holder

10. American Sankey Keg Coupler

11. Metal Keg Floor Support

12. Casters (x4) and Washers (x2)

13. Beer Line

14. Half Barrel Keg (not included)

15. Neoprene Washer

16. Hose Clamp

17. Spanner Wrench

18. Tower Plug

19. Rear Knockout Plug

20. Tower Gasket

21. Screws (4)

Tools Needed:

- Wrench

- Flat Head Screwdriver

- Pair of Pliers/Clamp Crimper

For additional information

visit edgestar.com

Summary of content (4 pages)

PAGE 1
KC2000 Kegerator Installation Guide 1 15 2 3 16 4 5 6 17 9 8 18 10 13 19 7 11 20 14 12 1. 2. 3. 4. 5. 6. 7. Faucet Handle Faucet Beer Tower Guard Rail Drip Tray CO2 Regulator CO2 Tube 21 8. CO2 Cylinder (supplied empty) 9. Cylinder Holder 10. American Sankey Keg Coupler 11. Metal Keg Floor Support 12. Casters (x4) and Washers (x2) 13. Beer Line 14. Half Barrel Keg (not included) Tools Needed: - Wrench - Flat Head Screwdriver - Pair of Pliers/Clamp Crimper 15. 16. 17. 18. 19. 20. 21.
PAGE 2
1 Install Caster Wheels Make sure unit is empty (including white metal keg floor (#11). Carefully tip the beer dispenser on its side. Connect the casters (#12) to the cabinet by screwing in each metal bracket into one of four caster holes (casters in the front of the cabinet require the washers #12). Then carefully set the unit upright. Note: Allow the dispenser to stand in an upright position for 24 hours before plugging in the unit.
PAGE 3
7 Connect Regulator to CO2 Cylinder 8 Before you start, make sure the CO2 cylinder (#8) is full and the valve is closed completely by turning the knob clockwise until it stops. Attach the CO2 regulator (#6) to the CO2 cylinder by screwing the hex nut on the right side of the regulator onto the cylinder valve. Hand tighten the nut until it stops and then slightly tighten from there with a wrench or pliers. Now mount the CO2 cylinder holder (#9) to the cabinet.
PAGE 4
13 Calibrating the Regulator (A) With the shut-off valve on the regulator (#6) closed (lever in the 9 o’clock position), open the valve on the gas cylinder (#8) completely by turning it counterclockwise. (B) Slowly turn the regulator adjustment knob clockwise until the desired pressure is shown on the pressure gauge on the top. By turning the knob clockwise it will increase (+) pressure and counterclockwise will decrease (-) pressure.