Owner's Manual

Note: The kegerator is equipped with a temperature memory function. If power is suddenly

lost, the previously set temperature will be saved and the Kegerator will return to this

setting once power is restored. Allow at least 24 hours before storing your items to allow

the setting temperature to be reached.

Caution: If you turned the unit o󰀨, please wait at least 5 minutes before turning it back on.

Normal Sounds

Your new kegerator may make noise during normal operation. Most of these sounds are normal. Hard

surfaces like the oor and walls can make sounds seem louder than they actually are.

The following describes several sounds you may hear and what may be making them:

• Rattling noises may come from the ow of the refrigerant or the water line. Items stored on top of the

kegerator can also make noises.

• The high e󰀩ciency compressor may make a pulsating or high-pitched sound.

• Water running from the evaporator to the water bin may make a splashing sound.

• As each cycle ends, you may hear a gurgling sound due to the refrigerant owing in your kegerator.

• You may hear air being forced over the condenser by the condenser fan.

Warning:

• Do not touch the power plug when your hands are wet.

• Never unplug the unit by pulling on the cord.

Temperature Alarm

If the interior temperature is higher than 73°F (23°C), “HI” is shown on the temperature

control panel and the temperature alarm will sound continuously after one hour.

This indicates that the inner temperature is too high. If the inner temperature is lower

than 23°F (-5°C), “LO” is shown on the temperature display panel and the temperature

alarm will sound continuously after one hour. If one of these situations occurs please

reference the troubleshooting section found in this manual or contact EdgeStar for support.